GE AEL18 Manual Del Propietario Y Instrucciones De Instalación página 12

Installation Instructions
5. PREPARE THE WINDOW AND
INSTALL THE CASE
Cut the window sash seal to the proper length.
A.
Peel off the backing and attach the seal to the
underside of the window sash.
Open the window and mark the center of the
B.
window sill.
Carefully slide the case into the window and
C.
the top mounting rail. Pull the bottom of the
case forward so that the bottom mounting rail
is tight against the back of the window stool.
Mount the case to the window sill using 2
Stool
Assemble the V-support and V-support bracket
D.
with Type F nut and bolt
Sill angle
bracket
V-support
Type F bolt
and nut
12
Type E bolt
and nut
Right
5. PREPARE THE WINDOW AND
INSTALL THE CASE (continues)
Position the V-supports
E.
on the case bottom so
that they will be near the
outside wall. Attach a
V-support to each side
of the bottom of the case
with Type E bolts, 2 for
each support.
Adjust sill angle brackets to rest on sill.
F.
G.
to the vertical window sashes. Drill pilot holes
and attach the top corners with 2 type C
screws.
Type C
screw
V-support
Sill
Type C
screw
49-7798