en
Parking, transport and storage
Park-System (see fig. 24)
(not for use with Powerbrushes
SEB 228 / EB03 and SEB 236 / EB01)
The Park-System allows you to park the
telescopic wand and the suction unit on
the vacuum cleaner during brief pauses.
^ Insert the parking clip attachment on
the suction unit into the parking slot
from above.
If the vacuum is on an incline, e.g. a
ramp, slide the tube sections of the
telescopic wand all the way in.
Turning on and off with the
Park-System
(depending on model)
The vacuum cleaner is automatically
turned off if you insert the suction unit
with the parking slot into the
Park-System.
Lifting the suction unit out turns the
vacuum cleaner automatically back on
using the last selected power level.
Park-System for storage (see fig. 25)
,
Turn the vacuum cleaner off
after use. Unplug the power plug
from the electrical outlet.
^ Stand the vacuum cleaner upright.
It is helpful to completely insert the
tubes into the telescopic wand.
14
^ Insert the suction unit with the
parking slot from above into either
side of the Park-System (cannot be
used with Powerbrushes SEB 228 /
EB03 and SEB 236 / EB01), see
figure 25 for details.
This makes the vacuum cleaner easier
to carry and store.
Maintenance and care
,
Turn off and unplug the vacuum
cleaner before performing any
maintenance work.
The Miele filter system consists of the
following three components.
– Filter bag
– Exhaust filter
– Dust compartment filter
Each of these components must be
changed periodically to maintain the
vacuum cleaner's efficiency.
Only use Miele filter bags, filters and
accessories with the "Original Miele"
logo. Only then can the suction
power of the vacuum cleaner reach
its optimum potential for the best
possible cleaning results.
,
The use of filter bags made of
paper or a similar material, or filter
bags with a cardboard retaining
plate can lead to serious damage to
the vacuum cleaner and may
possibly voiding the warranty, just
as with the use of filter bags without
the "Original Miele" logo.