Publicidad
Idiomas disponibles
Idiomas disponibles
Prepare the Hood
NOTE: Since this manual covers many range hood models, some details in the following
1 ] If present, remove all protective polyfilm from the hood and/or parts.
2 ] Using the finger cup (AVSF1-2, MTR1 Series) or the tab (AVSC1 Series), remove the grease
3 ] Remove the EZ1 brackets from inside the hood by cutting off the tie wrap. Remove both
4 ] Remove the wiring cover (shaded part on illustration below) by sliding it out from the hood
10
illustrations may sligthly differ from your unit.
filters from the hood by pushing down
B
screws holding damper assembly to hood. Remove parts bag (captured behind the damper
assembly). Remove damper assembly from inside the hood and keep the screws for further
use.
EZ1
BRACKETS
and set it aside.
and tilting filters out
C
.
SCR EWS
DAMPER
ASSEMBLY
Publicidad
