Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning
6
1. Disconnect the power cord
from the shaver.
2. Apply some hand soap and
some water to the outer foil.
3. Rotate the lock ring to unlock
the OFF/ON switch.
4. Press the OFF/ON switch for
more than 2 seconds to
activate the turbo mode for
"sonic" vibration cleaning.
or
flash around
•
randomly.
After about 20 seconds, it
•
will be automatically turned
off, or you can turn it off by
pressing the OFF/ON switch.
5. Remove the outer foil section
and press the OFF/ON switch
for more than 2 seconds to
activate the turbo mode for
"sonic" vibration cleaning and
clean it with running water.
6. Wipe off any drops of water
with a dry cloth.
7. Dry the outer foil section and
the shaver completely.
Caution for turbo mode
Shaving in turbo mode may damage your skin. Turn the shaver
•
off and then on again to cancel turbo mode.
Do not place your fingers on the OFF/ON switch while using
•
the shaver. This may cause the shaver to turn off or enter turbo
mode.
Replacing the system outer foil and the inner
blades
system outer foil
inner blade
Replacing the system outer foil
2
3
once every year
once every two years
1. Press the foil frame release
buttons and lift the outer foil
section upwards as illustrated.
2. Press the system outer foil
release buttons and pull down
the system outer foil as
illustrated.
3. Insert the system outer foil until
it clicks.
Always attach the system
•
outer foil in proper direction.
Always insert the system
•
outer foil to the foil frame
when attaching to the shaver.
Publicidad
