Proper Installation And Maintenance - GE PNRQ20RBL Manual Del Propietário

IMPORTANT SAFETY INFORMATION.
READ ALL INSTRUCTIONS BEFORE USING.

PROPER INSTALLATION AND MAINTENANCE

This Reverse Osmosis system must be properly installed and located in accordance with the Installation
Instructions before it is used.
Extended non-use of the Reverse Osmosis system.
If the system has not been used for one week or more,
open the RO water faucet and allow the system to
drain. Close the RO water faucet and allow the system
to regenerate the water supply.
Recommended installation is under the sink. However,
the unit can be installed in a remote location, up to 20
feet away from the sink.
See parts list to obtain additional materials
from GE.
at a first floor sink may result in some loss of flow rate
tank will improve this performance. An RVKIT can be
used.
If Reverse Osmosis system is connected to a refrigerator
icemaker, a special icemaker connection kit is required
(RVKIT). Do not use copper tubing for the connection
between the Reverse Osmosis system and the
refrigerator.
Sanitize upon installation of the Reverse Osmosis system
and after servicing inner parts, including replacement
of prefilter, postfilter and Reverse Osmosis cartridge. It is
important to have clean hands while handling inner parts
of the system.
See the Sanitizing the Reverse Osmosis System section.
This Reverse Osmosis system contains a replaceable
treatment component critical for effective reduction of
total dissolved solids. This product water shall be tested
periodically to verify that the system is performing
satisfactorily. See the The Water Test Kit section.
BE SURE TO FOLLOW ALL APPLICABLE STATE
AND LOCAL CODES.
CAUTION:
property damage due to water leakage:
Read and follow these instruction before installation and
use of this system.
plumbing codes.
Protect from freezing, remove filter cartridge when
temperatures are expected to drop below 40° F (4.4° C).
Do not install systems in areas where ambient
temperatures may go above 110° F (43.3° C).
operating water temperature of this filter system is
100°F (37.8°C).
kPa). If your water pressure exceeds 80 psi (552 kPa),
READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.
SAVE THESE INSTRUCTIONS
To reduce the risk associated with
MUST comply with all state and local
you should install a pressure limiting valve. Contact a
plumbing professional if you are uncertain how to check
your water pressure.
occur. If water hammer conditions exist, you should
install a water hammer arrester. Contact a plumbing
professional if you are uncertain how to check for this
condition.
water system, a device for controlling pressure due to
thermal expansion should be installed.
CAUTION:
To reduce the risk associated with
property damage due to water leakage:
near filter system, cartridges, plastic fittings or plastic
plumbing.
deteriorate plastic.
plastic fittings, as damage may occur if over tightening
occurs.
a drilling tool when selecting the position to mount the
bracket.
being struck by other items used in the area of
installation.
weight of the system when installed and full of water.
leaks.
800.663.6060 (Canada-English),
800.362-3869 (Canada-French) if collets are missing
from any fittings to obtain replacements.
every 6 months, at the rated capacity or sooner if a
noticeable reduction in flow rate occurs.
or sooner if a noticeable reduction in filtration efficiency
occurs.
GEAppliances.com
3