Publicidad
Idiomas disponibles
Idiomas disponibles
EN
5.
Untighten the screw (21) to loosen the lock
handle (22).
6.
Open up the lock handle (22).
7.
Lift the one end of the cylinder (13) and then pull
the other end out from the drive shaft.
8.
Remove the cylinder.
9.
Insert one end of a new cylinder into the drive
shaft and then place the other end into the lock
handle.
10. Lock down the lock handle and tighten the screw
to secure the cylinder.
Follow the instructions as mentioned above while
replacing a tine cylinder.
5.3
STORE THE MACHINE
• Remove the safety key.
• Remove the battery pack(s).
• Clean the machine before storage.
• Make sure the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose
or damaged parts. If it is necessary, follow these
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person at an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
6
TROUBLESHOOTING
PROBLEM
Abnormal noise. Foreign objects
13
NOTE
POSSIBLE
SOLUTION
CAUSE
Switch off the
on the cylinder
dethatcher/
are hitting the
scarifier, wait
dethatcher/
until the cylinder
scarifier.
has stopped ro-
tating. Remove
the foreign ob-
jects.
English
PROBLEM
Engine perform-
ance drops.
Imprecise scari-
fying/ dethatch-
ing result.
Motor will not
start.
The dethatcher
is hard to push.
Motor is run-
ning, but cylin-
der is not rotat-
ing.
* If you cannot find the solution to these problems, go
to the service center.
10
POSSIBLE
SOLUTION
CAUSE
Soil is too firm.
Adjust working
depth.
Housing clog-
Clean housing.
ged.
Cylinder badly
Replace the cyl-
worn.
inder.
Cylinder worn.
Replace the cyl-
inder.
Wrong working
Adjust working
depth.
depth.
Battery is not
Ensure that the
secure.
battery is fully
secured in the
machine. Refer
to Install the
Battery section
in this manual.
Battery is not
Charge the bat-
charged.
tery pack ac-
cording to the
instructions in-
cluded with your
model.
Safety key is
Insert the safety
not in place.
key.
Blocked by for-
Switch off the
eign objects.
motor, wait until
the tine cylinder
comes to a
complete stop.
Remove the for-
eign objects. Af-
ter approxi-
mately one mi-
nute, switch on
the dethatcher/
scarifier.
The grass is too
Mow the lawn
high.
before de-
thatching/scarif-
ing.
Belt torn.
Contact cus-
tomer service.
Publicidad
