Publicidad
Idiomas disponibles
Idiomas disponibles
4.1.5
CONNECT THE BATTERY TO THE
PRODUCT
WARNING
Only use greenworks original batteries with the
product.
1.
Make sure that the battery is fully charged.
2.
Push the battery into the battery slot. The battery
locks into position when you hear a click.
Note: If the battery does not move easily into the
battery compartment, the battery is not installed
correctly. This can cause damage to the product.
3.
Make sure that the battery is installed correctly.
Note: To remove the battery, press the battery
release button then pull the battery out.
4.2
OPERATE THE PRODUCT
1.
Push the trigger once to turn on the light.
English
2.
Push the trigger again to switch lighting modes.
(high, low, SOS, off).
Note: This product has magnets on the back of
the product that can be used to hang on metal
surfaces.
5
MAINTENANCE
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or
do the maintenance work on the product.
5.1
EXAMINE THE BATTERY AND THE
BATTERY CHARGER
1.
Examine the battery for any damage, such as
cracks.
2.
Make sure that the connection cord of the battery
charger is not damaged and that there are no
cracks in the charger.
5.2
CLEAN THE PRODUCT, THE BATTERY
AND THE BATTERY CHARGER
1.
Clean the product with a dry cloth after use.
2.
Clean the battery and battery charger with a dry
cloth. Keep the battery guide tracks clean.
3.
Make sure that the terminals on the battery and
the battery charger are clean before the battery is
put in the battery charger or the product.
4.
Do not use strong solvents or detergents on the
plastic housing or components.
6
TRANSPORTATION, STORAGE AND
DISPOSAL
6.1
TRANSPORTATION AND STORAGE
• The supplied Li-ion batteries obey the Dangerous
Goods Legislation requirements.
• Obey the special requirement on package and
labels for commercial transportation, including by
third parties and forwarding agents.
7
IMPORTANT
EN
Publicidad
