Descargar Imprimir esta página

AEG FR 5621 Instrucciones De Servicio página 26

Freidora de zonas frías

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
General Safety Instructions
Read the operating instructions carefully before putting the
appliance into operation and keep the instructions including the
warranty, the receipt and, if possible, the box with the internal
packing. If you give this device to other people, please also pass
on the operating instructions.
The appliance is designed exclusively for private use and for
the envisaged purpose. This appliance is not fit for commer-
cial use. Do not use it outdoors. Keep it away from sources
of heat, direct sunlight, humidity (never dip it into any liquid)
and sharp edges. Do not use the appliance with wet hands.
If the appliance is humid or wet, unplug it immediately.
When cleaning or putting it away, switch off the appliance
and always pull out the plug from the socket (pull the plug
itself, not the lead) if the appliance is not being used and
remove the attached accessories.
Do not operate the machine without supervision. If you
leave the room you should always turn the device off.
Remove the plug from the socket.
The device and the mains lead have to be checked regularly
for signs of damage. If damage is found the device must not
be used.
Do not try to repair the appliance on your own. Always
contact an authorized technician. To avoid the exposure
to danger, always have a faulty cable be replaced only by
the manufacturer, by our customer service or by a qualified
person and with a cable of the same type.
Use only original spare parts.
Pay careful attention to the following "Special Safety Instruc-
tions".
Children and Frail Individuals
In order to ensure your children's safety, please keep all
packaging (plastic bags, boxes, polystyrene etc.) out of their
reach.
WARNING!
Caution! Do not allow small children to play with the foil
as there is a danger of suffocation!
This device is not intended to be used by individuals (includ-
ing children) who have restricted physical, sensory or mental
abilities and/or insufficient knowledge and/or experience, un-
less they are supervised by an individual who is responsible
for their safety or have received instructions on how to use
the device.
Children should be supervised at all times in order to ensure
that they do not play with the device.
Symbols in these Instructions for Use
Important information for your safety is specially marked. It is
essential to comply with these instructions in order to avoid ac-
cidents and prevent damage to the machine:
WARNING:
This warns you of dangers to your health and indicates
possible injury risks.
26
CAUTION:
This refers to possible hazards to the machine or other
objects.
NOTE: This highlights tips and information.
Special Safety Instructions for this Device
WARNING:
Do not close the lid of the deep fat fryer during operation,
as the oil might overflow and cause a fire. The lid should
only be used for protection during storage after the oil has
cooled down.
Never add water to the oil!
Oils and fats may burn when overheated. Please be ca-
reful! Do not forget to switch the device off after use! First
turn the thermostat to the lowest position and then remove
the mains plug.
CAUTION:
OVERHEATING OF THE HEATING ELEMENT
Please note this important information if you would like to
use fat in the deep fat fryer!
The fat has to be melted slowly so that it can enclose the
heating element.
When fat is placed in the deep fat fryer for the first time
or melted again, there is a danger of overheating if the
selected temperature is too high!
Placing fat in the deep fat fryer for the first time
Liquefy the fat beforehand in a separate vessel.
WARNING:
Do not heat the fat above 50°C in order to prevent injury
when transferring it from the vessel to the deep fat fryer.
Transfer the liquefied fat to the frying fat container.
Once the required oil level has been reached you can set
the desired temperature on the thermostat.
Reheating hardened fat in the deep fat fryer
If the fat in the deep fat fryer has become hard, it is difficult
to know how much it has already melted down at the heating
element.
Turn the thermostat slowly up until the control lamp shows
that the heating is working.
STOP! Do not turn any further! The heating will now
slowly heat up the fat.
A short time later the heating switches off again.
Turn the heating on again by readjusting the thermostat.
Repeat the process until the fat has melted.
Please do not operate the device with an external timer or a
separate remote control system.

Publicidad

loading