Hart HPHD01 Manual Del Operador página 6

OPERATION
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended can
result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Hammer drilling in concrete, brick, or other masonry
 Drilling in all types of wood products (lumber, plywood,
paneling, composition board, and hard board), ceramics,
plastics, fiberglass, laminates, and metals; driving screws
into wood and drywall with screwdriver bits
CAUTION:
This drill is not intended to be used for mixing concrete,
drywall, grout or other similar types of viscous mixtures.
Failure to obey this caution could cause poor performance,
possible injury, and will void your warranty.
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 11.
To lock the switch trigger, place the direction of rotation

selector in the center position.
Insert the battery pack into the battery port as shown.

Make sure the latch on the battery pack snaps into place

and the battery pack is secured in the product before
beginning operation.
Depress the latch and pull to release and remove the

battery pack.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
VARIABLE SPEED SWITCH TRIGGER
See Figure 3, page 11.
The variable speed switch trigger delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
To turn the drill ON, depress the switch trigger. To turn it
OFF, release the switch trigger and allow the chuck to come
to a complete stop.
The LED light, located on the base of the tool, will turn on
when the switch trigger is depressed.
NOTE: A whistling or ringing noise coming from the switch
during use is a normal part of the switch function.
NOTE: Running at low speeds under constant usage may
cause the drill to become overheated. If this occurs, cool
the drill by running it without a load and at full speed.
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE/CENTER LOCK)
See Figure 3, page 11.
Set the direction of rotation selector in the OFF (center
lock) position to lock the switch trigger and help prevent
accidental starting when not in use.
Position the direction of rotation selector to the left of the
switch trigger for forward drilling. Position the selector to
the right of the switch trigger to reverse the direction.
NOTE: The drill will not run unless the direction of rotation
selector is pushed fully to the left or right.
NOTICE:
To prevent gear damage, always allow the chuck to
come to a complete stop before changing the direction
of rotation.
WARNING:
Battery tools are always in operating condition. Lock the
switch when not in use or carrying at your side, when
installing or removing the battery pack, and when installing
or removing bits.
INSTALLING/REMOVING BITS
See Figures 4 - 5, page 11.
The arrows on the keyless chuck indicate which direction
to rotate the chuck sleeve to tighten or release the drill bit.
Do not use a wrench to tighten or loosen the chuck jaws.
To install bits, lock the switch trigger.

Open or close the chuck jaws until the opening is slightly

larger than the bit size you intend to use.
Raise the front of the drill slightly and insert the drill bit.

6 - English