Astera LEO Fresnel Manual Del Usuario página 11

empty. In addition to the powerCON TRUE1 input/output connectors, the LeoFresnel
also has a 3Pin XLR input for use with external DC sources. The external DC input
will accept voltages from 12VDC to 48VDC. The external DC source should be
able to supply at least 250W. If you are using two RuntimeExtenders to power
the LeoFresnel via the external DC input, you must use 14.4V batteries only. The
polarity for the external DC input is Pin 1 Ground, Pin 2 DC+. Pin 3 is not used. It is
not possible to charge the internal battery via the DC input.
10. Rigging
The LeoFresnel is equipped
with AirlineTracks on all four
sides to attach various Astera
mounting accessories. When
installing accessories on the
AirlineTracks,
audibly click into place!
that can be attached to the yoke of the LeoFresnel is included with the product.
Yoke (AF250-YK) attachment with YokeBase (AF250-YKB) - Quick Release
BaseLock
Quick Release
they must
With the included yoke, LeoFresnel can be easily
hung. When hanging, always secure with a safety
wire at the safety eyelet on top of the light's housing.
Make sure the light cannot drop more than 20cm if
primary mounting fails.
The LeoFresnel can also be mounted on tripods. For
this purpose, a TVMP (TV to motion picture) adapter
To attach the LeoFresnel yoke, the two YokeBases must first be
inserted into the AirlineTracks on opposite sides. To secure the
YokeBase, turn the BaseLock clockwise.
The scales in the AirlineTracks help to ensure that the same
position is selected on both sides. There is a default position for
the YokeBase.
You can move the YokeBase to balance the light or to
use it in a different configuration.
It is important that the YokeBase
is oriented so that the opening
of the V points downward. When the light is properly
prepared, the yoke can be inserted into the YokeBases
from the bottom up.
~ 11 ~