Astera LEO Fresnel Manual Del Usuario página 12

The yoke is attached to the YokeBases
with a Quick Release system. To release
the Yoke, first loosen the Tilt Lock. This
acts as a safety for the Quick Release.
Once the Tilt Lock is loose, press the
Quick Release buttons on each YokeBase
to release the fixture from the Yoke. Make
sure to hold the fixture securely while
releasing it.
Attention: Only unscrew
YokeBase if Yoke is detached!
Mounting options with Yoke (AF250-YK)
TVMP Adapter (AX-TVMP)
The TVMP adapter has a 1/2" thread on top
and comes with a 1/2" bolt with washer. With
this bolt the TVMP adapter can be attached
to the hole of the LeoFresnel Yoke.
This allows the LeoFresnel to be mounted
on stands using the BabyPin (5/8") receiver
or the JuniorPin (1-1/8").
27.4
In this application, the TVMP T-Bolt can be
stowed on a dedicated thread on the Yoke
49.7
to prevent it from being lost.
The LeoFresnel Yoke has a mounting
hole allowing for the use of up to 1/2" or
M12 bolt. On both sides of the Yoke there
is a BrickMount (PB15-BMO), to which
suitable Astera accessories, such as a
RuntimeExtender (REX1) can be attached.
49.7
~ 12 ~
Tilt Lock