Stardom SR4-SB3 Manual Del Usuario página 6

Step 4 Mount your hard drives onto the removable drive tray and secure it with the screws included in the
accessory kit to avoid any damage to the hard drive due to accidental movements.
Step 5 When the hard drive installation has been completed, insert the hard drive tray into the system
horizontally and secure the latch into place.
Step 6 Connect the AC power cable to the SR4-SB3, and then plug the AC power to the wall socket.
Boot-up the unit.
Step 7 Set the storage mode using the LCD and buttons on the front (please refer to section 5 for front
panel and LCD information).
Step 8 Connect the cable to the PC and the SR4-SB3 port.
Step 9 After boot-up, your operating system will automatically detect the storage capacity of your hard
drives. Please follow the operating system instructions to configure and format your drives. The
formatted drives can be configured for the RAID setup.
5. Description of Front Panel Operation and LCD Information
Level 0
EXTERNAL 4
BAY
HARDWARE
RAID
Level 1 Level 2
Create One RAID RAID 0 / RAID 5
Quick Setup
Delete All RAID
Identify Disk
Disk Manager
Show Disk Info
Identify RAID
Create RAID
Delete RAID
RAID Info
RAID
Manager
Change RAID
Pwd
Rebuilding Priority Highest/High/Medium/Low/Lowest
Standby Timer
System Info
Change Password < Password >
Logout From
Menu
System
Alarm Control
Manager
Hardware Monitor
SOHORAID SR4 User Manual
Level 3
Disk 1
Disk 2
Disk 3
Disk 4
< Disk Info >
Select RAID
RAID 0 / RAID 5
Select RAID
< Password >
< 99999min >
Firmware Version
< Y or N >
Mute the Buzzer
Voltage Monitor
Temp. Monitor
FAN Monitor
6
Level 4
Select Disk
Check Disk LED
Check Disk LED
Check Disk LED
Check Disk LED
Select Disk
for RAID setup
for System Info
< 3.3V / 5V / 12V >
< Temp. >
<Fan Speed/Fan
Level>