Belkin OmniView SOHO F1DS102Lea Guía De Instalación Rápida página 2

Single-Switch Installation
This section provides complete instructions for the hardware setup of a single KVM Switch.
(F1DS102Lea or F1DS104Lea)
Installing the KVM Switch
The KVM Switch is a plug-and-play device for installation. For a quick start on installation
and operation, please follow the instructions below for the setup sequence:
Step 1.
Connect the shared keyboard, monitor,
and mouse (also speaker set and
microphone) to the console port of the
KVM Switch.
Step 2.
Connect each of your computers to the
KVM Switch, using the USB KVM cable,
and audio and mic cables.
Step 3.
Power up your KVM Switch by connecting the external power adapter to it.
Step 4.
Power up the connected computers one by one. After your computers are powered
up, the keyboard and mouse will be recognized and now you can begin operating the
KVM Switch.
NOTE: Since the USB interface is hot-pluggable, you don't have to turn off the computer before making
connections to the KVM Switch.