Johnson MANANTIAL Serie Manual De Instrucciones página 31

E. Maintenance and service
Heat Pump main unit disassembly
If want to check and maintain the top main parts of the unit, should disassembly
the cover of the unit, follow the below steps (Fig.5, 6) to process.
1. Move up the control panel and its components-1 (including control panel,
deco-rative panel, decorative aluminum profile, decorative strip) vertically
15-20mm, then pull it out horizontally to separate hook A-2 from hook A-3 until
exposed butt splice connector;
2. Disconnect control panel with butt splice connector;
3. Remove all screws-5 from the bottom of the top cover.
4. Release the power line from the top cover of fixed terminal, to prevent the
power line stuck when move up the top cover.
5. Finally, remove the block objects (e.g. air ducts etc.) from the air inlet/
outlet, holding both sides of the top covers and move it up.
CLOCK ON/OFF
TIMER MODE
1
(Fig.5)
2
2
(Fig.6)
12
3
4
6
5
3
V.1