Cherubini Plug & Play RX Instrucciones página 25

SETTING THE FIRST REMOTE CONTROL
This operation can only be performed when the motor is new, or after a total delete of
the memory.
During this step, power up only one motor at time!
T1: First remote control to be set
+
A B
T1
AUTOMATIC DISABLING OF THE FIRST
REMOTE CONTROL SETTING FUNCTION
Every time you connect the power supply to the motor, you have 3 hours to store the
first remote control. After this time, the ability to store the remote control is disabled.
To reset the timer of the function you have to disconnect and reconnect the power
supply to the motor.
CONFIRMATION OF THE MOTOR DIRECTION
If the shutter is already completely open, you have first to drive it down by about
20 cm.
Press button A or C and drive the rolling shutter to the opening position.
Keep the button A or C pressed until the motor stops automatically.
Press button B (stop) for about 2 seconds.
The motor performs a short downwards movement. After this confirmation movement the
motor brings back the rolling shutter to the opening position.
Tn: Already programmed remote control
A
?
C
Tn
Now the drive direction is corrictly detected.
B
T1
B
Tn (2 sec)
25
B
T1 (2 sec)
confirm