Cherubini Plug & Play RX Instrucciones página 30

SETTING THE A530058 POCKET REMOTE CONTROL
NB: The new pocket remote control can be set only after programming of a previous
remote control as the traditional Cherubini remote controls (Skipper or Giro - 3 buttons
Up-Down-Stop remote control).
HOW TO PROCEED TO SET THE BUTTON ON THE POCKET REMOTE CONTROL
Tn: Already programmed remote control
Tx: Pocket remote control to be set
+
A B
Tn
After to have pressed for minimal 2 seconds one of the 4 buttons on the pocket remote
control, this one will be memorized on the step-by-step mode (UP-STOP-DOWN-STOP).
The following buttons will be not memorized and have to be done with previous described
sequence, and could be used to move additional Plug&Play RX motors.
DELETING ONE BUTTON ON THE POCKET REMOTE CONTROL
The buttons saved may be deleted individually according to the following sequence:
Tn: Already programmed remote control
Tx: Pocket remote control with button to be deleted
+
A B
Tn
To confirm the operation the motor will do a short shunt and the button, which has to be
pressed for minimal 2 second, will be deleted.
+
B C
Tn
A
Tn
30
2
1
3 4
Tx (2 sec)
2
1
3 4
Tx (2 sec)