Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Problem
The washer stops.
Fills with the wrong
temperature water.
52
English
Untitled-4 52
Untitled-4 52
• Plug the power cord into a live electrical outlet.
• Check the fuse or reset the circuit breaker.
• Close the door and press Start/Pause (Hold to Start) to
start the washer. For your safety, the washer will not
tumble or spin unless the door is closed.
• Before the washer starts to fill, it will make a series of
clicking noises to check the door lock and does a quick
drain.
• There may be a pause or soak period in the cycle. Wait
briefly and the washer may start.
• Make sure the mesh filter of the water supply hose at
the faucets is not clogged. Periodically clean the mesh
filter.
• If the washer is not supplied with sufficient power,
the washer temporarily will not drain or spin. As soon
as the washer regains sufficient power, it will operate
normally.
• Fully open both taps.
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct taps.
Flush water lines.
• Make sure your water heater is set to supply hot water
with a minimum temperature of 120 °F (49 °C) at the
tap. Also, check the water heater capacity and recovery
rate.
• Disconnect the hoses and clean the mesh filters. The
mesh filters may be clogged.
• While the washer fills, the water temperature may
change as the automatic temperature control feature
checks incoming water temperature. This is normal.
• While the washer fills, you may notice just hot and/or
just cold water going through the dispenser when cold
or warm temperatures are selected. This is a normal
function of the automatic temperature control feature
as the washer determines the water temperature.
Action
2023-06-22
2023-06-22
3:30:10
3:30:10
Publicidad
