Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly Accessories - Figure B
Fitting
• Insert the appropriate accessory into the
front of the appliance as show in Figure B.
• Make sure the accessory is fully pushed in.
B
Charging the battery
WARNING:
supplied charger.
• Before first use, the battery must be
charged for at least 10 hours.
• Place the appliance on the charging
bracket whenever it is not in use.
WARNING:
to empty all contents and dry thoroughly if
needed to avoid damage to your appliance.
• Make sure the appliance is switched off.
• Place the appliance on the charging
bracket (5).
• Plug in the charger.
• Leave the appliance to charge for at least
9 hours.
NOTE: While charging, the charger may
become warm. This is normal and does not
indicate a problem. The appliance can be
left connected to the charger indefinitely.
WARNING:
battery at ambient temperatures below 50
°F or above 104 °F.
Switching On - Figure C
• To switch the appliance on, depress
the on/off button (1). Once the button is
released the vacuum will turn off.
C
This manual downloaded from http://www.manualowl.com
For use only with the
Before charging, be sure
Do not charge the
Dry pick up
• For everyday spills of dry material.
• Do not fill the dust bowl (3) beyond the
end of the intake chute.
Wet and dry pick up
• For everyday spills of dry material, use
your appliance without the squeegee
accessory.
CAUTION: Your product is designed for
light spills only.
• This vacuum can also be used to pick up
everyday liquid spills. Use the squeegee
accessory on non-absorbent, hard
surfaces. On absorbent surfaces, such
as carpet, your appliance will pick up wet
spills better without the accessory.
• For best performance on hard surface wet
pickups, insert squeegee into the bowl
nozzle opening.
• For best results when using this
accessory, hold the appliance at an angle
of 45° and pull it slowly towards you.
• Do not fill the bowl beyond the end of the
intake chute. If there is any liquid in the
bowl, do not turn the unit upside down,
sideways, point the nozzle upward, or
shake the vac excessively.
• After picking up liquid substances clean
the vac and filter immediately. Mold and
mildew may form if the unit is not properly
cleaned after wet pickups.
• If charging in a vertical position, be sure to
empty all liquid contents to avoid damage
to your appliance.
Optimizing the suction force
In order to keep the suction force optimised,
the filters must be cleared regularly during use.
EMPTYING AND CLEANING
THE PRODUCT.
Removing the dust bowl and
filters - Figures D & E
WARNING:
and should be cleaned regularly.
• Press the bowl release button (2) and pull
the dust bowl (3) straight off as shown in
Figure D.
D
4
The filters are reusable
Publicidad
