Publicidad
Idiomas disponibles
Idiomas disponibles
Residual risks
Even when the device is used properly and all safety
regulations are complied with, there still may be
some residual risks.
WARNING !
Wear eye protective goggles ! Wear gloves!
Keep childrenaway from acids and filled
batteries.
Corrosion Hazard !
Battery acid is highly caustic.
First Aid
Rinse out any acid splashed into the eyes
immediately using clear water for several
minutes. Consult a doctor immediately.
Neutralise acid splashes on skin or clothes
immediately using acid neutraliser or soap
suds and rinse with plenty of water.
If acid is consumed, consult a doctor
immediately.
Emergency procedure
Conduct a first-aid procedure adequate to the injury
and summon qualified medical attendance as quickly
as possible. Protect the injured person from further
harm and calm them down. If you seek help, state the
following pieces of information: 1. Accident site,
2. Accident type, 3. Number of injured persons,
4. Injury type(s)
Mains Connection
Operation is only allowed with a safety switch
against stray current (RCD max. stray current of
30mA).
Before putting into operation, a qualified electrician
must check whether electric safety measures required
are in place. Any national regulations in this regard
must be complied with.
Electric connection to a socket.
It is necessary to make sure the connecting socket
was not near water and humidity and the plug was
protected against humidity.
Check the voltage. Technical data given on the type
label must correspond with electric network voltage.
Only use splash proof extension cables approved for
outdoor purposes.
Check the cable and/or socket for damages before
the appliance putting into operation.
Never use the charger when the cable, plug or the
machine is damaged by external influences. In case
damage let repaired in authorized workshop
To avoid danger, a damaged mains supply pipe must
be replaced by the manufacturer. Do not under any
circumstances attempt any repair yourself.
Cable connections to be separated by pulling the
plug only. Pulling the cable could damage both the
cable and plug. As a result, electric safety would no
longer be guaranteed.
Over-temperature protection
The power will automatically be reduced should the
apparatus heat up too much during charging. This will
protect the apparatus.
Symbols
WARNING/Caution!
Warning against dangerous electric
voltage
Read the operating instructions to reduce
the risk of injury.
Wear eye protective goggles !
Wear gloves!
Unplug the machine before any work
on it.
Keep dry at all times. Never expose tool
to rain.
Charger to be used in closed spaces only.
~
AC Current
Plus – positive terminal
Minus – negative terminal
This equipment is in safety class II.
Direct Current
CE marking
ENGLISH
23
Publicidad
