Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT INSTALLATION
Installation
Pease read these instructions carefully before
installing your FreshSpa. Failure to do so could
result in flooding, leaking or damage to the
product.
1. Existing toilet seat removal
a. Lift hinge covers and use flathead or
Phillips-head screwdriver to remove
the mounting bolts. Alternatively, you
may need to loosen the mounting bolts
underneath the seat.
b. Remove the toilet seat, and set the seat,
mounting bolts, and hardware aside.
Step 1b
2. Turn off water supply valve and flush toilet
a. Turn water supply valve off to stop the
flow of water.
b. Flush toilet and hold down handle to
completely empty tank.
c. Disconnect water supply hose from toilet
tank; do not disconnect from the water
supply valve.
Step 2c
3. Connect cold water T-Valve to the toilet
tank fill valve
a. Install the ⅞" cold water T-Valve with one
or both of the large rubber washers to
the incoming water connection on the
bottom of your toilet tank.
b. Connect the cold water supply line
coming from the wall to the bottom of the
T-Valve.
Step 3
4. Connect bidet hose to T-Valve
Connect one end of the braided-metal cold
water bidet hose to the remaining open side of
the installed T-Valve.
Step 4
FOR AMBIENT TEMPERATURE MODEL,
STOP HERE AND PROCEED TO "INSTALLING
THE BIDET ATTACHMENT" ON PAGE 10.
FOR DUAL TEMPERATURE MODEL,
CONTINUE.
7
Publicidad
