Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT INSTALLATION
Installation (Cont'd)
5. Install the hot water supply cap
a. If you are only connecting the cold water
supply, then you must install the hot
water supply cap (provided - see Page 5)
over the hot water connection on your
bidet (see diagram).
b. After installing hot water cap, proceed to
"Installing the Bidet Attachment" on Page
10. If you wish to also connect your hot
water supply, proceed to the next steps.
Step 5a
IMPORTANT: Failure to connect or cap
the hot water supply will result in leaking
during use.
6. Disconnect the hot water supply
a. Locate the hot water supply line in your
bathroom under your sink/washbasin
and turn the water supply valve all the
way off.
b. Drain the hot water line by turning the
sink tap on the hot setting until no more
water comes out.
c. Disconnect hot water supply hose to sink
from shut-off valve. You may have to use
a ⅜" compatible wrench or a similar tool
(not supplied).
Step 6c
8
NOTE: There may be some residual
water in the hose; use a small container
or towel to catch any residual water.
7. Install the hot water ⅜" T-Valve and the
small rubber washers as needed onto the
hot water shut-off valve under the sink
8. Reconnect hot water supply line to open
end (top) of T-Valve
Steps 7,8
9. If not already removed, unscrew the
pressure cap covering the pressure
connector on the T-Valve
a. Slide the pressure cap over the open
end of the of hot water flex tubing with
the inside threads facing towards the
open end.
Step 9a
b. Push the hot water flex tubing over the
pressure connector.
Publicidad
