Anker A2519 Manual Del Usuario página 3

English
LED Indicator
Solid blue for 3 seconds, then off
Solid blue
Flashing blue
Flashing green
• • You cannot charge your device wirelessly in these scenarios:
using a case with a magnetic/iron plate;
T
O O
using a case with a pop socket;
O O
using an ultra-thick (> 5 mm) protective phone case.
O O
• • Do not place any foreign objects between your device and the
wireless charger's surface, including metal pads on a car mount,
credit cards, door keys, coins, metal, or NFC cards, which will
make wireless charging fail or cause overheating.
• • Wireless chargers make charging more convenient than wired
chargers, but confined by current wireless technology, their
charging speed is slower than that of wired chargers.
• • High temperatures will reduce charging speed and restrict power,
which is a phenomenon common to all wireless chargers. It is
recommended that you charge your device in environments with
temperatures below 25°C / 77°F.
• • Both the protective phone case and the position of your device on
the wireless charger will affect the charging speed. The farther it
is placed from the center of the wireless charger, the slower the
charging speed will be.
Important Safety Instructions
• Avoid dropping.
•
• • Do not disassemble.
• • Do not expose to liquids.
• • For the safest and fastest charge, use original or certified cables.
01
Status
Connected to power
Charging mobile device
Metal or abnormal objects detected
Loose connection
Re-plug the adapter and try again
• This product is suitable for moderate climates only.
•
• • The maximum ambient temperature during use of this product must not
exceed 40°C.
• • Open flame sources, such as candles, must not be placed on this product.
• • Only use a dry cloth or brush to clean this product.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures: (1)
Reorient or relocate the receiving antenna. (2) Increase the separation between
the equipment and receiver. (3) Connect the equipment into an outlet on a
circuit different from that to which the receiver is connected. (4) Consult the
dealer or an experienced radio / TV technician for help.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance of 20 cm between the radiator & your body.
02