BH FITNESS G152X Instrucciones De Montaje Y Utilización página 38

Insert the weight selector pin (44) into
the selector post (39), Fig.23, and
tighten nut (U) securely, Fig.24A.
Next, attach one end of cable (65)
to the left arm plate for the Butterfly
exercise, Fig.24B, fit bolt (103) with
washers (119) and nut (125).
Do the same with the other end of
cable (65) for the right Butterfly
exercise arm.
Fit the plates (59) onto the pulleys
(56) as shownh in Fig.24C.
Take the end of the foot pull-up
cable (64) and by following the arrows
marked on the cable, Fig.24, pass it
through the first pulley (A1), as shown
in Fig.24.
Next, pass the same tip through lower
pulley (B1; C1) Fig.24.
Continue passing the tip of the cable
(64) through the third pulley (D1)
Fig.24. Attach the end of the cable to
the carabiner (60) and to chain (61),
position it on the end joined to the
support on the base, Fig.24.
Note: After a while you may notice
that steel cable slackens a little due to
the cable settling into position.
To remedy this just tension the steel
cable by changing the chain link (61).
30.- Fit the chain (62) onto the leg
accessory hook (41) Fig.24, to be able
to do the leg exercises.
31.- Attach the top casing (127) fitting
it over the upper body (1) so that it
slots onto the main body (5) Fig.25.
Fasten on using screws (97).
32.- Set the selector (70) as shown in
Fig.25 to be able to do the Butterfly
exercise.
POSITIONING THE WEIGHT
SEECTOR ROD.-
33.-Insert the weight selector (44) rod
into the orifice of the weights required
for the exercise, as shown in Fig.26.
34.-When the rod notch has been fed
through the weight selector tube (39),
turn the selector rod anticlockwise, so
that the rod is held into place as
shown in Fig.27. Check that the
selector is firmly in position and that it
does not protrude from the weight
selector. To remove the rod, turn it
clockwise and pull.
For optimum
conditions, the weights are already
marked with letters. By checking the
equivalence charts on the bottom of
the apparatus, you will be able to
check the exercised strength as the
meaning of each letter Fig.28 is
expressed in kilograms and pounds.
FOLDING THE SEAT.-
35.-To fold the seat, pull the safety rod
(71) and lift it in the direction of the
arrow as shown in Fig.29. The same
rod is used to put the seat back up.
Note: The seat can be put into two
different positions.
LEVELLING.-
36.-Once it has been firmly positioned
into place, check the base and ground
level of the machine. Levelling can be
improved by more or less swivelling
the adjustable feet (79) Fig.30.
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
38
control of exercise