Publicidad
Idiomas disponibles
Idiomas disponibles
Nozzle Color
Spray
Pattern
powerful
pinpoint for
Uses
very intense
cleaning
Metal or
concrete
Surfaces *
DO NOT use
on wood
*
glass, automobile paint, auto striping and trim, and delicate objects such as
fl owers and shrubs. Before spraying, check the item to be cleaned to assure
yourself that it is strong enough to resist damage from the force of the spray.
HOW TO APPLY
CHEMICALS/CLEANING
SOLVENTS
Applying chemicals or cleaning
solvents is a low pressure operation.
NOTE: Use only soaps and chemicals
designed for pressure washer use. Do
not use bleach.
To Apply chemicals:
1.
Press chemical
hose onto
barbed fi tting
located near high
pressure hose
connection of
pump as shown.
2.
Place other end of chemical
hose with fi lter on it into container
holding chemical/cleaning
solution.
NOTE: For every 7 gallons (26.5
liters) of water pumped 1 gallon
(3.8 liters) of chemical/cleaning
solution will be used.
Red
Yellow
0º
15º
intense
cleaning of
small areas
metal,
concrete, or
wood
The high pressure spray from your pressure washer is
capable of causing damage to surfaces such as wood,
Barbed
Fitting
Green
25º
intense
cleaning of
larger areas
metal,
concrete, or
wood
3.
Install low pressure (black)
nozzle into quick connect fi tting
of spray wand, see How To Use
Spray Wand paragraph in this
section.
4.
After use of chemicals, place
chemical hose into container of
clean water and draw clean water
through chemical injection system
to rinse system thoroughly. If
chemicals remain in the pump
it could be damaged. Pumps
damaged due to chemicals will
not be covered under warranty.
NOTE: Chemicals and soaps will not
siphon when spray wand is in the high
pressure setting.
11 - ENG
White
40º
low pressure
covers wide
applies
areas of
cleaning
cleaning
solutions
metal,
metal,
concrete,
concrete,
wood, or
wood, or vinyl
vinyl
Black
A16064
Publicidad
