Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLÈME
Engine will
not start (see
Engine Manual
for further
engine trouble-
shooting)
No or low
pressure
(initial use)
A16064
TROUBLE SHOOTING GUIDE
CAUSE
No fuel.
Pressure builds up after two
pulls on the recoil starter or
after initial use.
Choke lever in the "No
Choke" position.
Spark plug wire not
attached.
Engine ON/OFF switch in
OFF po si tion.
Choke lever in the "Choke"
position on a "hot" engine
or an engine that has been
exposed to thermal heat for
a long period of time.
Fuel valve closed
Spray wand not in high
pressure.
Low water supply.
Leak at high pressure hose
fitting.
Nozzle obstructed.
Water filter screen clogged.
Air in hose.
Choke lever in the "Choke"
position.
High pressure hose is too
long.
CORRECTION
Add Fuel.
Squeeze gun trigger to relieve
pres sure.
Move choke to the "Choke"
po si tion.
Attach spark plug wire.
Place engine ON/OFF switch
in ON position.
Move choke to the "No
Choke" po si tion.
Move the fuel valve lever to
the "Open" position.
See How to Use Spray Wand
instructions in the Operation
Section.
Water supply must be at least
5 GPM @ 20 PSI (137.9 kPa).
Repair leak. Apply sealant
tape if necessary.
See Nozzle Cleaning
instructions in the
Maintenance section.
Remove and clean filter.
Turn off the engine, then the
water source. Disconnect the
water source from the pump
inlet and turn the water source
on to remove all air from the
hose. When there is a steady
stream of water present, turn
water source off. Re- con nect
water source to pump inlet
and turn on wa ter source.
Squeeze trigger to re move
re main ing air
Move choke to the "No
Choke" po si tion.
Use high pressure hose under
100 feet.
16- ENG
Publicidad
