Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLÈME
Will not draw
chemicals
No or low
pressure
(after period
of normal
use)
Water leaking
at gun/
spray wand
connection
Water leaking
at pump
Pump
Pulsates
AWSC = Authorized Warranty Service Center
Recommended accessories for use with your pressure washer are available
for purchase from your local retailer or authorized service center. If you need
assistance in locating any accessory for your tool, please call 1-800-888-2468 or
visit our website www.excellpressurewasher.com.
accessories rated equal to or greater than the rating of the pressure washer.
CAUSE
Spray wand not in low
pressure.
Chemical filter clogged.
Chemical screen not in
cleaning solution.
Chemical too thick.
Pressure hose is too long
Chemical build up in
chemical injector.
Worn seal or packing
Worn or obstructed valves.
Worn unloader piston.
Worn or broken o-ring.
Loose hose connection.
Loose connections.
Piston packings worn.
Worn or broken o-rings.
Pump head or tubes
damaged from freezing.
Nozzle obstructed.
ACCESSORIES
The use of any other accessory not recommended for use
with this tool could be hazardous. Use only Excell branded
CORRECTION
See How to Use Spray Wand
paragraph in the Operation
Section.
Clean filter.
Make sure end of chemical
hose is fully submerged into
cleaning solution.
Dilute chemical. Chemical
should be the same
consistency as water.
Lengthen water supply hose
instead of high pressure hose.
Have parts cleaned or
replaced by AWSC.
Have replaced by AWSC.
Have replaced by AWSC.
Have replaced by AWSC.
Check and replace.
Tighten.
Tighten.
Have replaced by AWSC.
Have replaced by AWSC.
Have replaced by AWSC.
See Nozzle Cleaning
paragraph in the Maintenance
section for the correct
procedure.
17 - ENG
A16064
Publicidad
