Makita XHU10 Manual De Instrucciones página 10

7. Make sure the resin sleeves are attached on the
shear blades.
1
Fig.11
► 1 . Resin sleeve
8.
Apply some grease provided with the new shear
blades as illustrated.
Fig.12
► 1 . Grease
9. Hold the guide bar, and then slide out the shear
blades as shown in the figure.
Fig.13
► 1 . Guide bar 2. Shear blades
1
1
1 2
10. Attach the dust guard to the shear blades.
Fig.14
► 1 . Dust guard
11. Place the new shear blades on the tool so that
the resin sleeves fit in the holes in the gear. If the resin
sleeves on the pins come off mistakenly, put them into
the holes in the gear beforehand.
Fig.15
► 1 . Shear blades 2. Resin sleeve 3. Hole
10 ENGLISH
1
1
2
3