LIVARNO home 1115-S Instrucciones De Uso Y De Seguridad página 50

WARNING: Keep out of reach of
„
children. Swallowing can lead to chemical
burns, perforation of soft tissue, and death.
Severe burns can occur within 2 h of
ingestion. Seek medical attention
immediately.
z Assembly and installation
Please note: Take the product out of its
packaging and remove all packing material.
Check that all package contents are
„
present.
Check if the product or individual parts are
„
damaged. Should you detect damage, do
not use the product. Please contact the
retailer via the service address indicated.
Decide prior to mounting where the product
is to be mounted. Before drilling the fixing
holes, satisfy yourself that there is no danger
of drilling into or damaging gas or water
pipes or electricity cables in the position
where you are about to drill the holes. Use a
drill to drill the holes into the masonry.
Observe all safety instructions provided in
the operation and safety manual for your
drill. Otherwise there is a risk of serious or
fatal injury from electric shock.
Please note: The fixings included are
suitable for conventional solid masonry.
Please check independently what kind of
fixings are best suited for the surface on
which you intend to mount the light. If
necessary, you should seek the advice of an
expert.
What to consider when deciding where
to mount the product:
Ensure the product illuminates the desired
„
area.
Choose a mounting point which is clearly
„
visible and therefore suitable for creating a
convincing illusion of surveillance.
50
GB/IE/NI/CY/MT
The motion sensor has a detection range
„
(field of view) of 3 to 5 m. Make sure that
the motion sensor covers the desired area.
The recommended installation height is 2 to
„
3 m.
If possible, mount the light in a position
„
where it will not be exposed to dirt or dust
and is protected from rain and other
weathering effects.
Please note: The solar panel should be
positioned where it will be exposed to as
much direct sunlight as possible. Even partial
shade during the day can significantly
impair the charging process.
Orientation: The optimum alignment is
facing south. Choose an orientation facing
slightly to the west rather than slightly to the
east.
Mounting the light
Please note: Make sure that you mount the
wall bracket the correct way around. Refer to
Figure A for guidance.
Transfer the positions of the guide holes
„ „
of the wall bracket
point on the wall.
Drill two holes (dia. 6 mm) and insert the
„ „
matching wall plugs
Screw the wall bracket
„ „
by inserting the screws
guide holes into the wall plugs
3
firmly tightening them (see Fig. B).
Fix the dummy camera
„ „
bracket.
Insert the thread
„ „ 13
the wall bracket
5
knob onto the thread from below (see
6
Fig. C). Ensure that it is fixed firmly in
place.
You can then adjust the position of the
„ „
dummy camera
1
vertically using the ball joint
to the mounting
5
(see Fig. B).
12
firmly in place
5
through the
11
and
12
onto the wall
1
through the opening in
and screw the star
horizontally and
(see Fig. D).
4
3