LIVARNO home 1115-S Instrucciones De Uso Y De Seguridad página 51

z First-time operation
Charging the battery
The battery is charged in all operating
modes. To optimise initial charging, leave
the product switched off curing charging.
Please note: The battery is fully charged
after it has been well exposed to sunlight for
7 to 8 hours. The duration of the charging
process depends on the battery's charge
level and the quality of the sunlight.
Using the remote control
Please note: The batteries supplied are
already inserted into the product and fitted
with an isolator strip. Remove this strip to
start using the product.
z Operation
The product can be operated in three
different modes. The operating mode is
selected using the remote control
Please note: The solar panel will turn on
the product in twilight or darkness in the
mode you have set.
Please note: Battery charging via the solar
panel does not depend on which mode is
selected. The battery is charged continuously
at all times.
First, turn the product on by pressing the
„ „
ON/OFF button
7
Mode: Sensor mode
Press the "Sensor mode" button on the
„ „
remote control
10
If the motion sensor detects movement
„ „
within its range, the product will light up at
maximum brightness.
If no further movement is detected after
„ „
approx. 30 seconds, the LEDs will switch off.
Once the LEDs are off and the motion
„ „
�
10
�
(see fig. A).
sensor is in standby, the signal LED
flash red (see Fig. A).
You can also initiate sensor mode by
„ „
pressing the ON/OFF button
Mode: Flash
Press the "Flash" button on the remote
„ „
control �
10
The LEDs will flash for approx. 30 seconds.
„ „
"Sensor mode" is now activated (see
"Mode: Sensor mode").
Mode: 75% brightness
Press the "75%" button on the remote
„ „
control �
10
The product will light up with low
„ „
brightness. The motion sensor is inactive in
this mode.
Switching the product off
You can switch the product off using the
„ „
remote control by pressing the ON/
10
OFF button �
7
Please note: You can still operate the
product using the remote control.
To do this, press the "Sensor mode" button.
„ „
You can also switch the product off using the
ON/OFF button.
z Replacing the batteries
(remote control)
Open the battery compartment of the
„ „
remote control �
10
Squeeze the tab and remove the battery
„ „
compartment.
Remove the depleted battery and dispose
„ „
of it properly.
Insert a new battery into the battery
„ „
compartment, taking care to ensure correct
polarity (+/-).
will
9
�
7
GB/IE/NI/CY/MT
51