Publicidad
Idiomas disponibles
Idiomas disponibles
Features
Rear Panel
1. Media Panel: Button controls for the USB/SD, FM
radio, and Bluetooth audio sources. These controls
include mode selection and playback options. See
Media Panel
below for more information.
Note: A USB drive or SD card must contain playable
files in order for it to appear properly in the media
panel's display.
2. USB Port: Connect your USB flash drive here to play
music. You can also use this port for charging a USB
device.
3. SD Card Slot: Insert your SD card here to play music.
4. Display: Shows the Media Panel modes: USB/SD,
FM radio, and Bluetooth. The icon for the currently
selected mode will be illuminated on the Display.
Note: The Display comes with a plastic protector on
it. Remove this for optimal viewing.
5. Mic Inputs (1/4" / 6.35 mm & XLR): Connect a dynamic microphone to the 1/4" (6.35 mm) or XLR
inputs. Control the volume of the inputs using the Mic Input Volume knobs.
6. Mic Input Volume Buttons: Press these buttons to increase or decrease the volume of the respective
input.
7. Aux Input (1/8" / 3.5 mm): Connect a CD player, digital media player, or other audio source to this 1/8"
(3.5 mm) stereo auxiliary input. Control the volume using the Aux Input Volume knob.
8. XLR Input (XLR): Connect a line-level mixer or musical instrument to this XLR line-level input. Control the
volume using the Aux Input Volume knob. Use this line-level input when linking together two Total PA
Glow 3 units.
9. Aux Input Volume Buttons: Press these buttons to increase or decrease the input volume of the Aux
Input and XLR Input.
10. Mix Out (XLR): Connect this XLR output to another active (powered) speaker. The level of the output is
controlled by the Mic Input Volume Buttons, Aux Input Volume Buttons, and Master Volume.
11. Mic Echo: Use this knob to increase or decrease the echo effect on the Mic Inputs.
12. Low EQ: Increases or decreases the low (bass) frequencies for Mic Inputs, Aux Input, and Media
Panel audio sources at a range between -12 dB to +12 dB.
13. High EQ: Increases or decreases the high (treble) frequencies for the Mic Inputs, Aux Input, and Media
Panel audio sources at a range between -12 dB to +12 dB.
14. Master Volume: Turn this knob to adjust the overall output volume of the loudspeaker.
15. Power LED: Indicates whether Total PA Glow 3 is powered on or off.
16. Clip LED: This LED will flash red if the signal from the inputs or media panel source is clipping. If this
happens, decrease the setting of the Mic Input Volume buttons, Aux Input Volume buttons, or Master
Volume knob.
17. Link Button: Press this button to link your speaker to another Total PA Glow 3. See
Linking Two Speakers
for more information.
2
4
1
11
12
13
6
6
5
5
5
5
3
14
15
16
9
17
7
18
8
10
Operation >
5
Publicidad
