Publicidad
Idiomas disponibles
Idiomas disponibles
Linking Two Speakers
To wirelessly link two Total PA Glow 3 speakers:
1. Power on both speakers using their Power Switches.
2. With no Bluetooth connected, press the Mode button on one Total PA Glow 3 to select Bluetooth as the
audio source, which appears as "bt" in the display. This will be the "secondary" speaker.
3. Press the Link button on a second Total PA Glow 3 to enter Stereo Link Mode. This will be the "primary"
speaker.
4. Wait up to 1 minute for the speakers to make the connection. Once the two speakers are linked, press
the Mode button on the "primary" speaker to select the desired audio source.
5. To disconnect, double-press the Link button on either speaker.
To link two Total PA Glow 3 speakers using cables:
1. With the Power Switch on each speaker turned to the off position, connect each speaker to a power
outlet.
2. Plug an XLR cable into the Mix Out located on the rear panel of one Total PA Glow 3 speaker. This
speaker (the master) is the one to which you will connect audio sources such as a Bluetooth device,
microphone, or USB flash drive.
3. Plug the other end of the XLR cable into the XLR Input on the rear panel of your second Total PA Glow
3 speaker. This second speaker will receive the audio from any devices connected to the first speaker
(the primary).
4. Power on both speakers using their Power Switches.
5. Connect your audio sources to the first speaker (the primary).
6. Make sure that each speaker's Master Volume control is set to the same position.
7. With one of your audio sources playing, gradually turn up the Aux Input Volume on the second Total PA
Glow 3 speaker until the volume of this speaker matches the volume of the first speaker (the primary).
9
Publicidad
