Qilive Q.6830 Manual Del Usuario página 12

Super-freeze function
EN
Enter super-freeze:
① By pressing the key "
When setting the centigrade temperature, " -30 " will be displayed in the temperature display area, if the
compressor continuous operates, the centigrade temperature indicator lamp "
When setting the Fahrenheit temperature, " -22 " will be displayed in the temperature display area, if the
compressor continuous operates, the Fahrenheit temperature indicator lamp "
Quit super-freeze:
① Power on after power failure;
② Continuous operation of compressor for 24 hours;
③ If sensor failure occurs under super-freeze mode, you can quit super-freeze;
④ Under super-freeze mode, you can quit the super-freeze mode by repressing the key "
High temperature alarm
The indicator lamp "
Power failure memory
During power failure, the sudden operating state of power failure will be locked, after power is recovered, the
operation shall be continued according to the setting before the power failure.
The super-freeze function will be quitted after power failure.
Failure code
If the failure happens, the display area will show corresponding error codes as shown as below table, the user
shall contact a specialist for maintenance, so as to make sure the normal use of freezer.
Fault code
Description
3.3. PLACEMENT
", the super-freeze indicator lamp "
" will be on for high temperature alarm.
E2
Temperature sensor failure
■ Before using the freezer, remove all packaging materials including
bottom cushions and foam pads and tapes inside the freezer, tear
off the protective film on the door and the freezer body.
■ The freezer should be placed in a well-ventilated indoor place;
the ground shall be flat, and sturdy..
■ Keep away from heat and avoid direct sunlight. Do not place the
freezer in moist or watery places to prevent rust or reduction of
insulating effect.
" will be on;
12
" will be on .
" will be on.
".