Bastilipo RC-Ecofluid-7 Manual De Instrucciones página 9

Warning
• Dear customer,
We thank you very much for having
purchased one product of ours. We
kindly ask you to read and save this
instruction manual
Assembly of the heater
• Remove the heater and all the
accessories from the carton. The base must
be fitted to the heater in accordance with
the details below.
NOTE: - It is important that the base are
fitted to the correct (i.e. bottom) end of the
heater.
1. Turn the heater upside down.
2. Position the base between the end fins.
3. Attach them to the heater using the U-
bolts and wing nuts supplied.
4. Tighten the wing nuts.
5. Turn the heater the right way up.
Parts description
Handle
Power switch
Thermostat knob
Oil filled fins
Base
Operating your oil-filled radiator
• Place the heater on the floor at least 90
cm away from the wall and any other
objects such as furniture, curtains or plants.
(Make sure the power supply used
.
corresponds to the one on the rating
label) With the thermostat control switch
and the power setting switches in the '0'
position, plug the heater into the main
power supply.
• Room temperature can be adjusted
using the thermostat Simply. Turn the
thermostat knob clockwise, to increase
the heat, and anti-clockwise to decrease
the temperature, until you reach the
desired temperature.
• Switch the heater to one of the following
power settings.
Radiator Power W
600 W
900 W
• The power switch lights up when
activated.
• Turning the thermostat control clockwise
will increase the "set" temperature.
• Turning the thermostat anti-clockwise
will decrease the "set" temperature.
• Do not cover the heater at any time
during operation. There is a risk of fire if
the heater is covered.
• Once you have finished using your
heater, turn the power switches, and the
thermostat control switch to the "0"
positions, and unplug from the mains
supply.
NOTE: - When the heaters are turned on
for the first time or after having not been
7
English
Elements
7 elements
9 elements