Publicidad
Idiomas disponibles
Idiomas disponibles
radiators or direct sunlight.
Avoid contact with skin, eyes and mucous
„
membranes! In the event of skin contact
with battery acid, rinse the affected area
immediately with plenty of clean water and
seek medical advice immediately!
WEAR PROTECTIVE GLOVES!
„
Leaking or damaged rechargeable
batteries can cause chemical burns
if they come into contact with skin.
Therefore, wear suitable protective gloves in
such cases.
In the event that of battery leaks, remove
„
battery from the product immediately to
avoid damage..
z Assembly and installation
Please note: dispose of all packaging
material.
Decide prior to installation where the
„
product is to be mounted.
Before drilling the fixing holes, satisfy
„
yourself that there is no danger of drilling
into or damaging gas or water pipes or
electricity cables in the position where you
are about to drill the holes.
Use a drill to drill the holes into the
„
masonry. Observe all safety instructions
provided in the operation and safety
manual for your drill. Otherwise there is a
risk of death or injury from electric shock.
When deciding where to mount the
light, pay attention to the following:
Ensure the product illuminates the desired
„ „
area. Make sure that the motion sensor
(see Fig. B) covers the desired area.
The motion sensor has a maximum
„ „
detection range of 8 m with a field of view
of approx. 100°.
Ensure that the motion sensor
„ „
position where street lighting will shine on it
at night. This may impair the function.
The recommended installation height is 2 to
„ „
4 m.
52
GB/IE/NI/CY/MT
Use the fixing holes
„ „
bracket
or corners) to mark the positions for drilling
the holes (see Fig. G).
Drill the holes (ø 5.5 mm, about 30 mm
„ „
deep).
Now insert the wall plugs
„ „
drilled holes (see Fig. G).
Offer the wall bracket
„ „
mounting surface and fix it in place with
the screws
Tighten the screws in the fixing holes and
„ „
align the LED solar spotlight
required.
The LED solar spotlight
„ „
be slotted onto the wall bracket (see Fig. H).
Aligning the LED Solar Spotlight
The lamp heads
individually adjusted both vertically and
horizontally at an angle of about 65°. To do
so, remove the fixing bolt
then align the lamp heads as desired.
Now align the motion sensor
that it faces directly towards the desired
detection zone.
Please note: the motion sensor has a field
of view of up to 100°.
Mounting the solar panel
You have the option of mounting the solar
panel
spotlight, on a flat surface (wall/roof), or on
the lawn, for example, using the ground
spike
product.
Please note: the solar panel
9
positioned where it will be exposed to as
much direct sunlight as possible. Even partial
shade during the day can significantly
impair the charging process.
Orientation:
is not in a
9
The optimum alignment is facing south. It is
better to face the solar panel slightly to the
west than slightly to the east.
in the spotlight wall
22
(for mounting on building walls
21
21
without fully tightening them.
24
11
(see Fig. B) can be
8
7
(see Fig. A) directly on the
1
(see Fig. D) supplied with the
17
into the
23
up to the
as
11
can now simply
(see Fig. B) and
, ensuring
9
should be
1
Publicidad
