Publicidad
Idiomas disponibles
Idiomas disponibles
quality of the sunlight.
z Exchanging the battery
Loosen the screws
„ „
25
the product. Fold the motion detector
upwards so that you can reach two of the
five screws (see Fig. I).
Carefully take the product apart. Take care
„ „
not to tug on the cables.
Loosen the screws
„ „
25
the battery compartment
the battery compartment (see Fig. I).
Remove the exhausted rechargeable
„ „
batteries
and dispose of it in
27
accordance with applicable guidelines.
Insert new rechargeable batteries. Only use
„ „
batteries of the same type (see section
'Technical specifications'). Pay attention to
the correct polarity when inserting batteries.
Screw the battery compartment back in
„ „
place.
Put the product together again. Attention:
„ „
Make sure not to get any cables trapped
between the different parts.
Refasten the five screws.
„ „
z Positioning the solar panel
Orientation
The optimum alignment is facing south. It is
better to face the solar panel slightly to the
west than slightly to the east.
Please note: to ensure the solar panel
functions as effectively as possible, make
sure that the surface of the solar panel
not dirty.
Now align the solar panel
position using the screw fixing
z Operating the LED solar
spotlight
Please note: Only operate the floodlight
with the solar panel supplied. Do not
54
GB/IE/NI/CY/MT
on the underside of
9
on the underside of
and remove
26
is
1
and fix it in
1
�
3
connect the floodlight or the solar panel to
any external devices.
When you switch the ON/OFF/AUTO
„ „
switch
(see Fig. C) to "ON" (II) the
16
spotlight remains permanently on.
When you switch the ON/OFF/AUTO
„ „
switch
to "OFF" (0) the spotlight
16
remains permanently off.
When you switch the ON/OFF/AUTO
„ „
switch
to "AUTO" (I) the spotlight is set
16
to AUTOMATIC mode. In this switch
position, the spotlight will switch on/off
according to control settings (for
illumination time, ambient light response
and detection range).
When the spotlight is turned off after the
„ „
specified burn time, it will continue to burn
with reduced brightness. This setting is only
activated when in "AUTO" mode, and is
deactivated if the switch is in the "ON"
position.
Please note: battery charging via the solar
panel does not depend on the position of
the ON/OFF/AUTO switch
is charged continuously at all times.
Information about functionality: in
twilight or darkness, the solar cell will turn
on the product as soon as the motion sensor
detects movement.
Adjusting the illumination time
Turn the TIME adjuster control
clockwise to set the spotlight ON time to the
maximum duration of 60 seconds. Turn the
TIME adjuster control
the spotlight ON time to the minimum
duration of 10 seconds.
Adjusting ambient light response
The LUX adjuster control
be used to adjust the "response" (i.e.
sensitivity) of the twilight sensor to the
ambient light level. Turn the adjuster control
clockwise to have the spotlight switch on at
ambient light levels up to as high as 50,000
lux. Turn the LUX adjuster control
. The battery
16
(see Fig. E)
13
anticlockwise to set
13
(see Fig. E) can
12
12
Publicidad
