Publicidad
Idiomas disponibles
Idiomas disponibles
M C
5
Keep Working
• When the guide is properly installed, make sure that the racks engage correctly with the gear.
• The gap between rack and gear should be 0.5mm.
5. Adjust
Spring limit switch
• To ensure safety, install safety stop blocks on both ends of the rails to prevent the gate from running out of the rail. Before
installing the main engine, make sure that the safety stop blocks are in place and whether it has the function of preventing
the gate from running out of the rail or safety range.
• Please make sure that the main engine and its components have good mechanical properties, and the gate can be operated
flexibly when manually moved before installing the main engine.
• Please note that for this product, one control can only drive one main engine, otherwise, the control system
will be damaged.
• Earth leakage circuit breaker must be installed in where the gate movement can be seen, and the minimum mounting height
is 1.5m to avoid being touched by children.
• After installation, please check whether the mechanical property is good or not, whether gate movement after manual unloc-
king is flexible or not, whether the installation for infrared sensor (optional) is correct and effective.
KEEP WORKiNG
05
Publicidad
