Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION TIPS
●Always stir and strain the material thoroughly before use.
●With any spraying job you should always ensure that you have properly prepared the surface to get the best
finish. That is, all surfaces are free from dust, dirt, rust and grease. Lightly pressure wash decks or exterior
surfaces and ensure that they are dry before spraying.
●Even though HVLP sprayers have very little overspray, it is recommended that you mask all edges and other
areas and use drop cloths to protect your floors and anything else in the spraying area that you wish lo
remain untouched.
●Skin that forms on the top of paint can clog the sprayer. Remove skin before mixing. Strain with a funnel with
a filter attached or through hosiery to remove any impurities that could clog system.
●Before starting have gloves, paper towels, rags etc. Available for unexpected spills.
FILLING THE CANISTER (FIG. F)
●Check to make sure that the canister is completely screwed onto the sprayer.
●Unscrew the quick refill lid ( #12 )
●Stand the sprayer firmly on a smooth and horizontal surface
●Pour the properly thinned and strained material to be sprayed into the canister (Fig. F).
●Clean any residual liquid from the threads or sides of the canister and sprayer.
●Starting the threads evenly, screw the lid completely onto the top fill canister. Check the lid to make sure it is
threaded on squarely and completely before picking up the sprayer.
ON / OFF SWITCH (Fig. G)
Squeeze to press the trigger (#11), trigger will actuate the switch inside the tool by the switch trigger lever
(#20) to turn on the tool. Release the trigger to turn off the tool.
SMART SELECT NOZZLE SELECTION (Fig. H, Fig. H1)
There ore three spray potterns to choose from:
Vertical Flat Jet
Horizontal Flat Jet
To select vertical Flat Jet , turn the air cap (#5) to horizontal
direction by turning the smart nozzle selector (#3)
clockwise until stop.
To select Horizontal Flat Jet, turn the air cap(#5) to vertical
direction by turning the smart nozzle selector (#3)
anticlockwise until stop
www.ELITETOOLS.co
14
Keep Working
Publicidad
