Publicidad
Idiomas disponibles
Idiomas disponibles
- Warm soapy water for water based materials
- Manufacturers recommended cleaning solution for oil based materials
●Screw on the canister back to the sprayer securely and vigorously shake the sprayer.
●Unscrew the canister and properly dispose of cleaning solution.
●Refill the canister with a small amount of new cleaning solution (Fig. N). Screw on the canister back the
sprayer. Reattach the spray gun unit to the power unit, plug in the cord and turn on the power unit.
●Spray the cleaning solution through the sprayer onto scrap material for 2 to 3 seconds (Fig. O).
●Turn the power unit off, and unplug the cord.
●Unscrew the canister from the sprayer.
●Remove the a-ring (#14), pickup tube (#15), check valve (#16), and quick refill lid(#12) from the sprayer. Clean
the parts with the cleaning brush in the appropriate cleaning solution (Fig. P).
Note: When removing the check valve, twist the check valve clockwise and then pull it out.(Fig P1)
●Unscrew the tip collar (#4) and remove all the parts of the spray nozzle (#3, #4, #5, #6, #7. #8) from the
sprayer. Remove the spray tip(#9) from the sprayer ( Fig. Q1). Clean all parts with the cleaning brush in the
appropriate cleaning solution (Fig. Q, Fig.Q1). Be sure to clean around check valve with brush (Fig Q insert)
●If using water based material, clean the sprayer by running water through pickup tube inlet as shown in Fig.
R. If using oil based materials, clean pickup tube inlet with the appropriate cleaning solution. Repeat until
sprayer is completely clean
● Dry all parts thoroughly.
● Properly dispose of cleaning solution.
●Place a drop of household oil into the inside of the sprayer from the hole for assembling the spray tip (Fig. S).
●Reassemble sprayer (Fig. T).
Note: Spray nozzle can only be assembled in one direction that the notch of the nozzle (#6) must align with
the skirt on spray unit housing(#10). Refer to Fig T1 for proper assembly. Note: The spray tip must be
assembled in the sprayer with the bumps on the spray tip in vertical direction
Note: Assemble the pickup tube(#15) and check valve (#16) by firmly pushing them onto the inlet on the
sprayer.
●Put all the accessories back into space.
MAINTENANCE
Use only mild soap and damp cloth to clean the power unit. Never let any liquid get inside the power unit;
never immerse any part of the power unit into a liquid.
Important! To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
(other than those listed in this manual) should be performed by authorized service centers or other
qualified service personnel, always using identical replacement parts.
●To check the filter, Unscrew the screws an back of the filter cover (#23) and remove the filter
cover(#23).Remove the filter as shown in Fig.U and inspect. Reassemble the liter and filter cover.
Important! Never operate the power unit without the filter in place. Debris could be sucked in and
interfere with the function of the power unit.
17
Keep Working
Publicidad
