Descargar Imprimir esta página

Amana RC517 Serie Manual Del Usuario página 14

Ocultar thumbs Ver también para RC517 Serie:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 57
Before Calling for Service
If oven does not operate:
• Confirm oven is plugged into dedicated circuit.
• Confirm oven is on earthed and polarized circuit.
(Contact electrician to confirm)
• Check fuse or circuit breaker.
If oven light does not work:
• Confirm light bulb is screwed in tightly.
• Confirm light bulb is not defective.
If oven operates intermittently:
• Check filter inlet and discharge areas
for obstructions.
If oven does not accept entries when pad is pressed:
• Open and close oven door. Press pad again.
If oven malfunctions:
• Unplug oven, wait for 1 minute, and plug in oven.
If oven operates, but will not heat food:
• Place one cup cool water in oven. Heat for one
minute. If water temperature does not rise, oven is
operating incorrectly.
Warning
To avoid electrical shock which can cause severe
personal injury or death, do not remove outer case at
any time. Only authorized servicer should remove
outer case.
Service Codes
During operation, display may show service codes:
Contact an authorized servicer if display shows any code
except "HOT", "HI", and "LO". Service must be performed
before using oven.
• If display shows "HOT", oven's magnetron tube is
overheated. Oven automatically interrupts cooking
sequence and turns on cooling fan until magnetron
tube reaches normal temperature. When
magnetron tube cools to normal temperature, oven
resumes normal operation.
• If display shows "HI" or "LO", input voltage is
too high or too low . Because cooking results vary
from the normal cooking pattern, oven is not usable
during this condition. Normal operation returns
once voltage returns to normal range.
When contacting supplier, provide product information
including model, serial, and manufacturing numbers, and
date of purchase. Model, serial, and manufacturing
numbers are located on product serial plate. Warranty
service must be performed by authorized servicer.
Amana also recommends contacting authorized servicer
if service is required after
warranty expires.
14
S1
CS
PCE1
PCE5
PCE6
FL
FH
PL
-HOT
H I
LO

Publicidad

loading

Este manual también es adecuado para:

Rc519 serie