or open up batteries/rechargeable
batteries. They could overheat, cause a fire
or explode.
Never throw batteries/rechargeable
batteries into fire or water.
Do not expose batteries/rechargeable
batteries to mechanical stress.
Avoid exposing batteries/rechargeable
batteries to extreme conditions and
temperatures, e.g. on radiators/barbecues
or in direct sunlight.
WARNING!
RISK OF COMBUSTION! The
50
minimum distance of 50cm from
heat sources must be maintained. Risk of
combustion if the lamp becomes too hot!
z Risk of leakage from
batteries/rechargeable
batteries
Avoid contact with skin, eyes and mucous
membranes! In the event of skin contact
with battery acid, rinse the affected area
immediately with plenty of clean water and
seek medical advice immediately!
WEAR PROTECTIVE GLOVES!
Leaking or damaged batteries/
rechargeable batteries can cause
chemical burns if they come into contact
with the skin. Therefore, always wear
suitable protective gloves in such situations.
In the event that a battery leaks, remove it
from the product immediately to avoid
damage.
z Before first-time use
Completely remove the packaging material
und check the barbecue lamp for damage.
Should you find any, register a complaint
about the barbecue lamp as described in the
section "Warranty claim processing".
38
GB/IE/NI/CY/MT
z Inserting the batteries
Unscrew the battery compartment cover
(see Fig. E) and take out the battery holder
. Place the 3 type AAA/LR03 batteries in
8
the battery holder
8
terminals match up with the terminal labels
marked on the battery holder. Slot the
battery holder
into the casing
8
barbecue lamp, making sure that the arrow
on the battery holder
the barbecue lamp (see Fig. F). Now screw
the battery compartment cover
the barbecue lamp.
z Replacing the batteries
Unscrew the battery compartment cover
(see Fig. E) and take out the battery holder
. Remove depleted batteries and dispose
8
of them properly. Place the 3 type AAA/
LR03 batteries in the battery holder
making sure the terminals match up with the
terminal labels marked on the battery holder.
Slot the battery holder
of the barbecue lamp, making sure that the
arrow on the battery holder
towards the barbecue lamp (see Fig. F).
Now screw the battery compartment cover
back on the barbecue lamp.
3
z Switching the barbecue
lamp ON/OFF
The barbecue lamp can be switched on/off
by means of the ON/OFF switch
z Fixing/setting up the
barbecue lamp
Only suitable for manual operation.
Alternatively, the barbecue lamp can be
attached to a metallic object by means of
the magnet
(see Fig. B). Make sure that
6
the surface is flat and level to ensure the
lamp is firmly attached. Surfaces that are
3
, making sure the
of the
4
is pointing towards
8
back on
3
3
,
8
into the casing
8
is pointing
8
�
5
4