Publicidad
Idiomas disponibles
Idiomas disponibles
10.3 Exchanging the battery
The meter's battery is easy to exchange by authorized technical personnel (our replacements only). Replaced
batteries must be disposed of according to relevant environmental regulations.
To exchange the battery open the meter´s calculator as described above in 10.2. Afterwards protect the calculator
against unauthorized opening using one of the numbered adhesive seals enclosed to the batteries (stick it upon the
seal destroyed). The added bar code label can be used for the purpose of documentation.
10.4 Mounting a power pack
If an external power supply is needed, only the power pack designed for our heat meter may be used.
To connect the power pack, first open the meter´s calculator as described above in 10.2. Then remove the battery
from the calculator and plug it into the battery connector in the power pack. Protect the power pack against
unauthorized opening using one of the numbered adhesive seals enclosed. The added bar code label can be used
for the purpose of documentation. (The battery is a backup in case of a power outage.)
The power pack cable (A) has two connectors; plug the one connector onto the contact fingers on the left hand side
of the PC board. Then feed the cable through the meter´s leftmost cable feedthrough (viewed from the front) after
removing the blind grommet. The other connector is to be plugged into the female connector on the PC board.
A
A
Page 12 of 50
Article no.: 1080621033
2022-02-04
Subject to technical change! Errors excepted.
Publicidad
