Publicidad
Idiomas disponibles
Idiomas disponibles
Level 3 / Statistics Loop:
Level 4 / Maximum Values Loop:
1) Maximum power
alternating with date
and time
5) Maximum temperature
difference
alternating with date
and time
Level 5 / Parametrizing Loop:
1) Parametrizing
„unit of energy"
8.1 Parametrizing loop
a) The following characteristics of the meters can be set on location, only once, by pushing the button or
alternatively using the „Device Monitor" software:
-
unit of energy (kWh; MWh; GJ; MMBTU; Gcal)
-
installation point (inlet flow; outlet flow).
These parametrizing options are only available when the amount of energy is still <= 10 kWh. Make sure that
these characteristics are set as needed before starting up the system.
Page 9 of 50
Article no.: 1080621033
2) Maximum flow
alternating with date
and time
2) Parametrizing
„installation point"
2022-02-04
1) – 30) Semimonthly
values:
date alternating with
heat energy,
cooling energy,
volume,
value tariff register 1,
1)
value tariff register 2.
(If the meter has 3 pulse
3) Maximum inlet flow
temperature
alternating with date
and time
Subject to technical change! Errors excepted.
inputs, their values
follow.
2)
)
4) Maximum outlet flow
temperature
alternating with date
and time
Publicidad
