Bresser TemeoTrend SQ Instrucciones De Uso página 19

Pay attention: The weather station can receive
the signals from up to 3 outdoor sensors and
display the data. Position the weather station
and outdoor sensor within the maximum
permitted reception range, which amounts
to about 50 meters under normal conditions.
The transmission of the radio signal can
be interrupted in some cases. If necessary,
remove the batteries from the weather station
and outdoor sensor and perform the above
mentioned steps once again.
Functions
Weather station
LCD-Display
Displays the current time, alarm time, indoor
and outdoor temperature. The TemeoTrend ST
(Type. No. 70-04401), TemeoTrend LG (Type.
No. 70-04402) and TemeoTrend JC (Type.
No. 70-04404) models additionally display the
weather forecast.
TemeoTrend LG (Type. No. 70-04402) and
TemeoTrend JC (Type. No. 70-04404) models
additionally display the relative humidity.
SNOOZE/LIGHT button (Fig. 1a, 1)
Press the button to activate the backlight. When
the alarm sounds, press the button to interrupt
the alarm and activate the snooze function.
SNOOZE button (Fig. 1b, 1)
When the alarm sounds, press the button to
interrupt the alarm and activate the snooze
function.
DISPLAY SET (TIME SET) button (Fig. 1, 5)
Press and hold down the button for about 2
seconds to change into the time setting mode.
Press the button in the time setting mode, to
skip to the next input field. Press and hold
down the button for about 2 seconds in the
setting mode to save the settings and exit the
setting mode.
ALARM SET button (Fig. 1, 2)
Press the button in the display mode to switch
the alarm on/off. Press the button in the alarm
mode to switch the alarm on/off. Press and
hold down the button for about 2 seconds in
the alarm mode to change into the alarm setting
mode. Press the button in the alarm setting
DE
GB
FR
NL
ES
IT
19