Descargar Imprimir esta página

Craftsman 247.881730 Manual Del Operador página 13

Publicidad

THROTTLE CONTROL
The throttle control is located on the rear of the engine. It regulates the
speed of the engine and will shut off the engine when moved into the
STOP position.
PRIMER
Depressing the primer forces fuel directly into
the engine's carburetor to aid in cold-weather
starting.
RECOIL STARTER HANDLE
This handle is used to manually start the engine.
ELECTRIC STARTER BUTTON
Pressing the electric starter button engages the engine's electric
starter when plugged into a 120V power source.
ELECTRIC STARTER OUTLET
Requires the use of a three-prong outdoor extension cord (included)
and a 120V power source/wall outlet.
OIL FILL
Engine oil level can be checked and oil added through the oil fill.
GAS CAP
Unthread the gas cap to add gasoline to the fuel tank.
AUGER
When engaged, the auger blades rotate and draw snow into the auger
housing.
CHUTE ASSEMBLY
Snow drawn into the auger housing is discharged out the chute
assembly.
AUGER CONTROL
AUGER
CONTROL
OPERATION
GO
13
The auger control is located on the left handle. Squeeze the control
grip against the handle to engage the auger and start snow throwing
action. Release to stop.
DRIVE CONTROL/ AUGER CONTROL LOCK
DRIVE
CONTROL
The drive control is located on the right handle. Squeeze the control
grip against the handle to engage the wheel drive. Release to stop.
The drive control also locks the auger control so you can operate
the chute directional control without interrupting the snow throwing
process. If the auger control is engaged simultaneously with the drive
control, the operator can release the auger control (on the left handle)
and the augers will remain engaged. Release both controls to stop the
augers and wheel drive.
NOTE: Always release the drive control before changing speeds.
Failure to do so will result in increased wear on your machine's drive
system.
OVERHEAD CHUTE DIRECTIONAL CONTROL
CHUTE DIRECTIONAL CONTROL
DISCHARGE
LEFT
The overhead chute directional control is located in the center of the
snow thrower between the handle panel and lower handle. To change
the direction in which snow is thrown, rotate the chute directional
control.
SKID SHOES
Position the skid shoes based on surface conditions. Adjust upward
for hard-packed snow. Adjust downward when operating on gravel or
crushed rock surfaces.
GO
ADJUSTABLE
CHUTE TILT
DISCHARGE
RIGHT

Publicidad

loading

Este manual también es adecuado para:

247.88173131as63ee799