Publicidad
5.
Place chute onto chute base and secure chute control head to
chute support bracket with clevis pin and cotter pin removed
earlier. See Figure 4.
6.
Finish securing chute control head to chute support bracket with
wing nut and hex screw removed earlier. See Figure 5.
7.
Insert the chute directional control into the support bracket on the
rear of the dash panel. See Figure 6.
8.
Remove the hairpin clip from the rear of the chute control head.
9.
Insert chute directional control into rear of the chute control head.
Secure the chute directional control to the chute control head with
the hairpin clip removed earlier. See Figure 7.
ASSEMBLY
Figure 4
Figure 5
9
Figure 6
Figure 7
Publicidad
