Publicidad
Idiomas disponibles
Idiomas disponibles
Built-in Outdoor Side Burner
Installation
◼
Unpack side burner. Remove all packaging materials and
remove side burner from carton.
◼
Place side burner into outdoor enclosure but leave enough
room in back to connect to gas supply.
Install 20 lb Propane Tank Tray
The tank tray should be secured to a fixed location that can be
easily accessed and will allow the gas pressure regulator/ hose
assembly to connect to the 20 lb propane tank without kinking
or putting strain on the gas pressure regulator/ hose assembly.
1.
Place the tank tray in a location that can be secured using
4 screws (supplied) through the predrilled holes.
2.
Use 4 screws to secure the tank tray. The typical location
for a 20 lb propane tank is within the enclosure where the
tank can be turned on and off easily.
Four 5/32-32 x 3/8" truss head screws
A.
NOTE: A bracket or shelf (not supplied) that is large enough to
keep a second 20 lb propane tank from being stored in the
storage area under the side burner is required to be mounted
inside the island.
INSTALLATION INSTRUCTIONS
Make Gas Connection
NOTE: If side burner is to be converted to Natural gas, follow
instructions in the "Gas Conversions" section.
20 lb Propane Tank
IMPORTANT: A 20 lb propane tank must be purchased
separately.
IMPORTANT: The 20 lb propane tank must be mounted and
secured.
IMPORTANT: The gas pressure regulator/hose assembly
supplied with the burner must be used. Replacement gas
pressure regulator/hose assembly specific to your model is
available from your outdoor grill dealer.
To Connect the 20 lb Propance Tank:
Check that the 20 lb LP propane tank is in the "OFF"
1.
position. If not, turn the valve clockwise until it stops.
2.
Check that the 20 lb LP propane tank valve has the proper
type-1 external male thread connections per ANSI Z21.81.
Check that the burner control knobs are in the "OFF"
3.
position.
4.
Remove any debris and inspect the valve connections,
port, and gas pressure regulator/hose assembly for
damage.
NOTE: Always keep the LP cylinder at 90°(upright) orientation
to provide vapor withdrawal.
10
Publicidad
