ESAB POWERCUT-1500 Manual De Instrucciones página 107

SECTION 2
2.6 SECONDARY (OUTPUT) CONNECTION
(REFER TO FIGURE BELOW)
The torch comes factory installed.
Connect your air supply to the inlet connection of the filter-regulator.
Prefiltered DRY AIR
SUPPLY (Customer
Supplied)
6.2 to 10.3 bar
(90 to 150 psig max)
DISCONNECT
Figure 2-1 PowerCut 1500 Interconnection Diagram
91
INSTALLATION
PRIMARY INPUT
POWER CABLE
FUSED
BOX
Clamp the work cable to the
workpiece.
workpiece is connected to an
approved earth ground with a
properly sized ground cable.
WORK
SAFETY
GROUND
Be sure the