Publicidad
Idiomas disponibles
Idiomas disponibles
6. Mount the Room Controller in the existing gang box with the
provided screws and attach the wall plate (press fit).
7. Turn on the power at the circuit breaker.
8. Test to see that the Room Controller is functioning by
pressing and holding the ON switch for 7-10 seconds. Your
load (lights) should turn ON.
NOTE: If your lights do not turn on, check that the live/load
wires are all connected according to the old switch. Turn off
power at the circuit breaker and check the wiring.
9. Place the OnCloud / WiZ Connected light fixtures that are
hardwired to the Room Controller circuit in pairing mode
NOTE: If the OnCloud / WiZ Connected light fixtures are
already installed and paired in the WiZ app, skip to #10.
a. Press and hold the ON and OFF buttons simultaneously for
5 seconds. The LED indicator will flash RED.
i. For first time pairing, follow with a short press of the
ON button.
ii. For previously paired, follow with a long press (3
seconds) of the ON button.
b. The LED indicator will flash RED/GREEN.
c. The fixtures are now in pairing mode and you can proceed
to WiZ App Setup.
NOTE: In the WiZ App, any OnCloud / WiZ Connected fixture(s)
must be added to a room prior to adding the Room Controller that
will control them.
10. WiZ APP SETUP – Refer to "WiZ Quick Setup Guide"
Publicidad
