Candy CIS642SCTT Manual De Instrucciones página 13

Using your Induction Hob
To start cooking
1. Touch the ON/OFF control.
After power on, the buzzer beeps once, all displays show
" – " or " – – ", indicating that the induction hob has entered
the state of standby mode.
2. Place a suitable pan on the cooking zone that
you wish to use.
• Make sure the bottom of the pan and the surface
of the cooking zone are clean and dry.
3. Touching the heating zone selection control, and
a indicator next to the key will flash.
4. Set a power level by touching the "-", "+", or slide along the "—"control,
or just touch any point of the "—".
Or
a. If you don't select a heat zone within 1 minute, the ceramic hob will
automatically switch off. You will need to start again at step 1.
b. You can modify the heat setting at any time during cooking.
c. If slide along the "—", power will vary from stage 2 to stage 8.
Press "-", power will decrease by one stage each time till stage 0.
Press "+", power will increase by one stage each time till stage 9.
Or
EN-12