Makita CJ106D Manual De Instrucciones página 7

• Choose appropriate temperature settings in
accordance with the usage environment for
continuous use.
• The battery cartridge, battery holder and con-
nectors must not be allowed to get wet during
washing and drying.
• The appliance is not to be used by young chil-
dren unless the controls have been pre-set by
a parent or guardian, or unless the child has
been adequately instructed on how to operate
the controls safely.
• Be careful not to touch the same part of the
skin with the heating section for a long time. If
the heating section touches the same part of the
skin for a long time, there is a possibility of low
temperature burns even at a relatively low tem-
perature (40 to 60 °C).
• Stop using the jacket when you feel it is hot.
• Never use the jacket while you are sleeping.
• In order to avoid the possibility of heatstroke,
disconnect the clothing when moving to
an environment having significantly higher
temperature.
• Check carefully on the marking
nal part of the cloth. Do not insert pins on the
cloth from external or internal parts.
• Remove the batteries from the jacket before
charging.
• Remove exhausted batteries from the jacket
and dispose of them safely.
• Before storing the jacket for a long period,
remove the batteries.
• Do not short-circuit the supply terminals.
Washing
• When washing the jacket, follow the instruc-
tions in the caution tag on the jacket.
• Before cleaning the jacket, remove the battery
holder and the battery cartridge and then place
the power cable in the battery pocket and
close the fastener.
Work area safety
Keep work area clean and well lit. Cluttered or
•
dark areas increase accident risk.
Electrical safety
• Do not expose the jacket to rain or wet condi-
tions. Water entering the jacket may increase the
risk of electric shock.
• Do not abuse the cord. Never use the cord
for carrying, pulling or unplugging the jacket.
Keep cord away from heat, oil, sharp edges.
• Do not connect power source to USB port.
Otherwise there is risk of fire. The USB port is only
intended for charging lower voltage device.
• Always place the cover onto the USB port
when not charging the lower voltage device.
• Do not insert a nail, wire, etc. into USB power
supply port. Otherwise a circuit short may cause
smoke and fire.
• Do not handle the cord and battery with wet or
greasy hand.
• Never use the jacket when the cord or plug is
damaged.
Always use the battery holder specified by
•
Makita.
• Do not leave any cord disconnected while the
battery power is supplied. Young children may
put the live plug in their mouth and cause injury.
• Do not connect the plug of the battery holder
to appliances other than the jacket specified
by Makita.
Personal safety
• Stay alert, watch what you are doing and use
common sense when using the jacket. Do not
use the jacket while you are tired or under the
influence of drugs, alcohol or medication. A
moment of inattention while using the jacket may
result in serious personal injury.
Jacket use and care
• Do not use the jacket if the switch does not
turn it on and off. Any jacket that cannot be
controlled with the switch is dangerous and must
be repaired.
• Maintain the jacket. Check for breakage of
parts and any other condition that may affect
the jacket's operation. If damaged, have the
in the inter-
jacket repaired before use.
• Use the jacket in accordance with these
instructions, taking into account the working
conditions and the work to be performed. Use
of the jacket for operations different from those
intended could result in a hazardous situation.
• If the fuse link has ruptured, return the jacket
to our authorized service center for repair.
Battery tool use and care
Recharge only with the charger specified by
1.
the manufacturer. A charger that is suitable for
one type of battery pack may create a risk of fire
when used with another battery pack.
Use power tools only with specifically desig-
2.
nated battery packs. Use of any other battery
packs may create a risk of injury and fire.
3. When battery pack is not in use, keep it away
from other metal objects, like paper clips,
coins, keys, nails, screws or other small metal
objects, that can make a connection from one
terminal to another. Shorting the battery termi-
nals together may cause burns or a fire.
4. Under abusive conditions, liquid may be
ejected from the battery; avoid contact. If con-
tact accidentally occurs, flush with water. If
liquid contacts eyes, additionally seek medical
help. Liquid ejected from the battery may cause
irritation or burns.
5. Do not use a battery pack or tool that is dam-
aged or modified. Damaged or modified batteries
may exhibit unpredictable behaviour resulting in
fire, explosion or risk of injury.
Do not expose a battery pack or tool to fire or
6.
excessive temperature. Exposure to fire or tem-
perature above 130 °C may cause explosion.
7. Follow all charging instructions and do not
charge the battery pack or tool outside the
temperature range specified in the instruc-
tions. Charging improperly or at temperatures
outside the specified range may damage the
battery and increase the risk of fire.
7 ENGLISH